Need help?

EN 1359:2017 Standard

wave
Save  

  Keywords:

#manufacturer #condensing #locations #maximum #specified

  Directive

Measuring instruments (MID) Directive (2014/32/EU)

  Last Official Journal reference

Wednesday 25th of August 2021

  Description:

Gas meters - Diaphragm gas meters

  Purpose

This European Standard specifies the requirements and tests for the construction, performance, safety and production of class 1,5 diaphragm gas meters (referred to as meters). This applies to meters with co-axial single pipe, or two pipe connections, that are used to measure volumes of fuel gases, which are within the limits of test gases of the 1st, 2nd and 3rd families described in EN 437. The meters have maximum working pressures not exceeding 0,5 bar and maximum actual flow rates not exceeding 160 m3h−1 over a minimum ambient temperature range of −10 °C to 40 °C and a gas temperature range as specified by the manufacturer with a minimum range of 40 K. This standard applies to meters with and without built-in temperature conversion that are installed in locations with vibration and shocks of low significance (see MID Annex 1 Chapter 1.3.2 (a), class M1). It also applies to meters in: -closed locations (indoor or outdoor with protection as specified by the manufacturer) both with condensing humidity or with non-condensing humidity; or, if specified by the manufacturer: -open locations (outdoor without any covering) both with condensing humidity and with non-condensing humidity; -in locations with electromagnetic disturbances corresponding to those likely to be found in residential, commercial and light industrial buildings (see MID Annex 1 Chapter 1.3.3 (a), class E1). Unless otherwise stated, all pressures given in this document are gauge pressure. Requirements for electronic indexes, batteries, valves incorporated in the meter and other additional functionalities are given in EN 16314. Unless otherwise stated in a particular test, the tests are carried out on meters that include additional functionality devices intended by the manufacturer. Clauses 1 to 9 and Annexes B and C are for design and type testing only. NOTE The content of OIML Publication 'International Recommendation R 137' has been taken into account in the drafting of this standard. If no specific requirements are given for test equipment, the instruments used should be traceable to a national or international reference standard and the uncertainty (2σ) should be better than 1/5 of the maximum value of the parameter to be tested. For differential results the repeatability (2σ)/resolution should be better than 1/5 of the maximum value of the parameter to be tested.

  Publication

Thursday 26th of August 2021

  Related Standards

EN 14236:2018

Measuring instruments (MID) Directive (2014/32/EU)

Ultrasonic domestic gas meters

EN 1359:1998

Measuring instruments (MID) Directive (2014/32/EU)

Gas meters - Diaphragm gas meters

EN 62059-32-1:2012

Measuring instruments (MID) Directive (2014/32/EU)

Electricity metering equipment - Dependability - Part 32-1: Durability - Testing of the stability of metrological characteristics ...

EN 12261:2018

Measuring instruments (MID) Directive (2014/32/EU)

Gas meters - Turbine gas meters

EN 62058-21:2010

Measuring instruments (MID) Directive (2014/32/EU)

Electricity metering equipment (a.c.) - Acceptance inspection - Part 21: Particular requirements for electromechanical meters for ...

EN 62058-11:2010

Measuring instruments (MID) Directive (2014/32/EU)

Electricity metering equipment (a.c.) - Acceptance inspection - Part 11: General acceptance inspection methods

  Stay up to date

  ACCESS

Search for a standard
GO

Register

Already a member?
Login

  OTHER APPLICATIONS

If you are interested in DO160 tests, you can give a try to our other free of charge software:
CE-Marking assistant, Version: 1.3.0