Need help?

EN 300 330 V2.1.1 Standard

wave
Save  

  Keywords:

#transmit #receive #devices #inductive #use

  Directive

Radio equipment Directive (2014/53/EU)

  Last Official Journal reference

Friday 1st of December 2023

  Description:

Short Range Devices (SRD); Radio equipment in the frequency range 9 kHz to 25 MHz and inductive loop systems in the frequency range 9 kHz to 30 MHz; Harmonised Standard covering the essential requirements of article 3.2 of Directive 2014/53/EU

  Purpose

The present document specifies technical characteristics and methods of measurements for the following Short Range Device major equipment types: 1) Generic Short range Devices including transmitters and receivers operating in the range from 9 kHz to 25 MHz; and 2) inductive loop transmitters and receivers operating from 9 kHz to 30 MHz including Radio Frequency Identification (RFID), Near Field Communication (NFC) and Electronic Article Surveillance (EAS) operating in LF and HF ranges. Also the present document covers fixed, mobile and portable stations. NOTE: If a system includes transponders, these are measured together with the transmitter. These radio equipment types are capable of operating in the permitted frequency bands within the 9 kHz to 30 MHz range as specified in table 1. Table 1: Short Range Devices within the 9 kHz to 30 MHz permitted frequency bands Frequency Bands/frequencies Applications Transmit and Receive 9 kHz to 90 kHz Inductive devices, Generic use Transmit and Receive 90 kHz to 119 kHz Inductive devices, Generic use Transmit and Receive 119 kHz to 140 kHz Inductive devices, Generic use Transmit and Receive 140 kHz to 148,5 kHz Inductive devices, Generic use Transmit and Receive 148,5 kHz to 5 MHz Inductive devices, Generic use Transmit and Receive 400 kHz to 600 kHz RFID only Transmit and Receive 5 MHz to 30 MHz Inductive devices, Generic use Transmit and Receive 3 155 kHz to 3 400 kHz Inductive devices, Generic use Transmit and Receive 984 kHz to 7 484 kHz (Note 3, Centre frequency is 4 234 kHz) Inductive devices, Railway applications Transmit and Receive 4 516 kHz Inductive devices, Railway applications Transmit and Receive 6 765 kHz to 6 795 kHz Inductive devices, Generic use Transmit and Receive 7 400 kHz to 8 800 kHz Inductive devices, Generic use Transmit and Receive 10 200 kHz to 11,000 MHz Inductive devices, Generic use Transmit and Receive 11,810 MHz to 15,310 MHz (Centre frequency is 13,56 MHz) RFID only Transmit and Receive 12,5 MHz to 20 MHz Inductive devices, Wireless healthcare Transmit and Receive 13,553 MHz to 13,567 MHz Inductive devices, Generic use Transmit and Receive 26,957 MHz to 27,283 MHz Inductive devices, Generic use Transmit and Receive 27,090 MHz to 27,100 MHz Inductive devices, Railway applications NOTE 1: In addition, it should be noted that other frequency bands may be available in a country within the frequency range 9 kHz to 30 MHz. NOTE 2: On non-harmonised parameters, national administrations may impose certain conditions such as the type of modulation, frequency, channel/frequency separations, maximum transmitter radiated power, duty cycle, and the inclusion of an automatic transmitter shut-off facility, as a condition for the issue of an Individual Rights for use of spectrum or General Authorization, or as a condition for use under "licence exemption" as it is in most cases for Short Range Devices. NOTE 3: Transmitting only on receipt of a Balise/Eurobalise tele-powering signal from a train. The frequency ranges and limits of the present document are based on the European Commission Decision for SRDs [i.10], CEPT/ERC/REC 70-03 [i.1]. When selecting parameters for new SRDs, which may have inherent safety of human life implications, manufacturers and users should pay particular attention to the potential for interference from other systems operating in the same or adjacent bands. The radio equipment, covered by the present document is divided into several classes which are dependent on the antenna used (see annex B). Three types of measuring methods are defined in the present document due to the varied nature of the antenna types for equipment used in this band. One method measures the RF carrier current, another measures the radiated H-field and the third conducted power. The present document covers the essential requirements of article 3.2 of Directive 2014/53/EU [i.4] under the conditions identified in annex A.

  Publication

Friday 10th of March 2017

  Essential Requirement

Article 3(2)

  Related Standards

EN 50360:2017

Radio equipment Directive (2014/53/EU)

Product standard to demonstrate the compliance of wireless communication devices, with the basic restrictions and exposure limit v...

EN 301 489-20 V2.2.1

Radio equipment Directive (2014/53/EU)

ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 20: Specific conditions for Mobile Earth Stati...

EN 303 980 V1.3.1

Radio equipment Directive (2014/53/EU)

Satellite Earth Stations and Systems (SES); Fixed and in-motion Earth Stations communicating with non-geostationary satellite syst...

EN 303 132 V2.1.1

Radio equipment Directive (2014/53/EU)

Maritime VHF survivor locating devices employing Digital Selective Calling (DSC Class M); Harmonised Standard for access to radio ...

EN 302 245 V2.2.1

Radio equipment Directive (2014/53/EU)

Transmitting equipment for the Digital Radio Mondiale (DRM) service; Harmonised Standard for access to radio spectrum

EN 302 077 V2.3.1

Radio equipment Directive (2014/53/EU)

Transmitting equipment for the Digital Audio Broadcasting (DAB) service; Harmonised Standard for access to radio spectrum

  Stay up to date

CELAB is Notified Body No.2037 for the EMC Directive and Italian office of a Notified Body for the RED Directive.

CELAB performs voluntary inspection activities on technical construction files to check their contents.

CELAB can accomplish all the required tests in order to affix the CE-marking related to EMC, LVD, RED, MDD, machines and many others.

CLICK HERE TO GET TESTS AND INFO ON THE EN 300 330 V2.1.1 STANDARD

  ACCESS

Search for a standard
GO

Register

Already a member?
Login

  OTHER APPLICATIONS

If you are interested in DO160 tests, you can give a try to our other free of charge software:
CE-Marking assistant, Version: 1.3.0